The wood working shop is located about 400 feet down flat shady winding road through the woods, off Johnson Rd. The shop was built in the early 1980 using oak and steel trusses. The shop's electrical is wired for three phase giving the option to run bigger machinery and using less power. The dust collection system runs throughout the shop with a 36" outside system and smaller inside dust collector. The dimensions of the building are 40' wide 112' long with 12' ceilings at the highest. The building is heated with wood and has a cement floor with electrical run under floor to key locations in the shop. The shop has an office, spray room and furnace room/storage. Located outside the shop is the well house, sawdust storage bin, and log rack used to stack logs above ground ready to saw into lumber. A list of the power tools in shop is as follows.
1 Powermatic 10" table saw single phase
1 Powermatic 10" table saw three phase
1 Sears 12" table saw single phase
1 12" Straight-line ripsaw
3 Jet shapers 1 horse single phase
1 Belsaw 12 molder planner single phase
1 24" three phase planner
1 massive 2-drum 48" three phase sander
1 6 x 48 belt sander single phase
1 drill press
1 band saw
1 spray gun system
1 horizontal boring machine
1 5-horse air compressor